Food gets the spotlight, but shoddy steel can kill you too.  Steel holds you up when you drive across bridges, or stand on the top floors of tall buildings.  The rate of failure is astounding.

William Upton, president of Vulcan Threaded Products, based in Pelham, Alabama, said a company team visited China in November 2006 to investigate how Chinese companies could manufacture a competing steel rod product so cheaply.

After observing "serious (safety) problems with the Chinese production," Vulcan purchased samples of the steel rod to have it tested by a certified U.S. lab, Upton said.

The results showed "133 failures out of the 222 samples tested -- an astonishing 60 percent failure rate," Upton said. "These results are unbelievable because in normal applications for this product, only a zero percent rate is acceptable."

The Steel Caucus in Congress is pushing the issue:

"When sub-standard steel goes into our roads, bridges, and skyscrapers, it threatens our safety and unnecessarily risks American lives," Rep. Jim Visclosky, an Indiana Democrat and chairman of the Congressional Steel Caucus, said in a statement after a caucus hearing on steel imports from China.

Imagine if a U.S. company had a 60% failure rate.  They would be pariahs.  But with China, its just "free trade."

TrackBack URI for this entry

Comments (1)

Subscribe to this comment's feed

President, Farming Company in KS
written by Elena Varela , September 04, 2008

Polluted steel is dangerous and costly. Our large engines are having bearings failure at a phenomenal rate. We can't afford the breakdowns caused by the steel bearings sent from China! But at least they are parts that remain on the ground.

If steel parts of an engine fail in a plane or helicopter, who will be left to tell the tale?

Imported rotten steel is worse than rotten food because the food will make enough people sick or cause enough deaths that we will eventually stop importing it!

I recently bought bearings on internet for a machine and paid $1.oo each. One of them failed almost immediately so I bought another bearing locally that was in old stock (American made) and paid $18.
Believe me, it was worth it to know that I have ONE GOOD bearing in that machine.

report abuse

vote down

vote up

Votes: +0

Write comment

Name

Title

Comment

smaller | bigger

Subscribe via email (Registered users only)

I have read and agree to the Terms of Usage.

Add Comment